Products and Applications

Our Products

Awesome Image

Advanced Lubrication nanotechnology

4 and 6 cylinder gasoline, propane or natural gas engines require 2oz bottle for the engine treatment. For optimum performance we strongly recommend applying MoreMPG to the Transmission, differential and transfer case if applicable.

  • Engines
  • A/ Transmissions
  • M/ Transmissions
  • Gearbox
  • Differentials
  • Wet Axles
  • Hydraulics
  • Hydrostatic
Awesome Image

Once treated it cleans & penetrates.

Through the carbon to get to the metal, using the finest quality in nanotechnology with a capacity to clean and seal the metal to a hard ceramic finish, will not allow the formulation of sludge and abrasive carbons, allowing the sealed piston rings to have the same spring effect as when the engine was new. MoreMPG™ also cleans and fuses to the walls of the cylinders and any other components in contact with oil. MoreMPG™ has been proven to reduce soot's in oil analysis in the range of 60 - 70%.

  • Engines
  • A/ Transmissions
  • M/ Transmissions
  • Gearbox
  • Differentials
  • Wet Axles
  • Hydraulics
  • Hydrostatic
Awesome Image

Quickly penetrates and dissolves,

Varnish, soot and carbon buildup without Solvents. MoreMPG™ fuses a permanent sub surface internal bond within metal at a molecule size of < 0.001 to 0.003 mm, up to 6 microns in dept of a ceramic shield of a glass like finish that provides a protection from abrasion by forming a near diamond hard surface film on and below metal surfaces. leaving the internal metal surfaces clean and as near new condition as possible and will not allow the formulation of sludge and abrasive carbons on or between parts, Keeps your engine clean

  • Engines
  • A/ Transmissions
  • M/ Transmissions
  • Gearbox
  • Differentials
  • Wet Axles
  • Hydraulics
  • Hydrostatic
Awesome Image

Save Fuel and reduce Emissions.

MoreMPG™ treated engines results due to the reaction of Oil on Hot Metal vs Oil on Hot Ceramic treated metal. When oil is in contact to hot metal it repels and on hot MoreMPG™ ceramic sealed metal, oil spreads out and won't run off, creating a near perfect seal around the piston rings and the sleeve almost eliminating blow-by which increases compression that creates a better burn equals to more horse power, saves fuel and significantly reduces un-burnt fuels. (Emissions). Enjoy the performance of that new Engine feeling.

  • More Compression
  • More Horsepower
  • Saves on Fuel
  • Reduces Emissions
  • Reduces Blow-by
  • More Torque
  • Reduces Friction
  • Reduces Wear
Awesome Image

MoreMPG™ can be applied to any system that requires lubrication

Yes MoreMPG™ can be applied to anything that requires lubrication. It can also be applied to Motorcycles and will not effect the clutch system. MoreMPG™ will bring back the performance like the day it was new. MoreMPG™ can be added to Diesel, gasoline engines wither 4 stroke or 2 stroke engines, Manual Transmissions, Sutomatic Transmissions, Gearboxes, Hydraulics and Hydrostatic it can be added to lawnmowers or weed eater.

  • Engines
  • A/ Transmissions
  • M/ Transmissions
  • Gearbox
  • Differentials
  • Wet Axles
  • Hydraulics
  • Hydrostatic

For Gasoline Passenger Cars and Trucks

4 and 6 cylinder gasoline, propane or natural gas engines require 2oz bottle for the engine treatment. For optimum performance we strongly recommend applying MoreMPG to the Transmission, differential and transfercase if applicable.

  • Engine 2oz
  • automatic transmission 2oz
  • differential 2oz
  • transfercase 2oz

dosagegasbanner gas2

Important Application Instructions:

Have engine at operating temperature and turn off the engine, apply MoreMPG to the engines oil then immediatly turn the engine back on, at this point the engine should be reved at around 1200 rpm for 2 minutes to allow the product to spread out through the engine. Then immediately drive for a minimum of 30km for gasoline vehicle.

gaspickupbanner gas

8 cylinder engines using gasoline, propane or natural gas engines require 4oz bottle for the engine treatment. For optimum performance we strongly recommend applying MoreMPG to the Transmission, differential and transfercase if applicable.

  • Engine 4oz
  • Automatic transmission 2oz
  • Manual transmission 4oz
  • Differential 4oz
  • Transfercase 4oz

Diesel Pickup Trucks

Disel pickup truck require 6oz bottle for the engine treatment. For optimum performance we strongly recommend applying MoreMPG to the Transmission, differential and transfercase if applicable.

  • Engine 6oz
  • Automatic transmission 2oz
  • Manual transmission 4oz
  • Differential 4oz
  • Transfercase 4oz

 

 is just the right amount for a Diesel Pickup Trucks

 

diesel pickups

Important Application Instructions

For treating a diesel engine and or automatic transmissions which must be at operating temperature then turn off the engine, and apply MoreMPG to the engines oil and or Automatic transmission. After application immediately turn the engine back on, at this point the engine should be reved up to around 1200 rpm for 2 minutes to allow the product to spread out through the engine. Then immediately drive for a minimum of 50km for Diesel Engines. Differentials and manual transmissions can be applied while the unit is cool.

Commercial and Industrial Diesel Engines Under 300HP

straittruck

Disel engines such as strait trucks under 300 HP require 8oz bottle for the engine treatment. For optimum performance we strongly recommend applying MoreMPG to the Transmission and differential.

  • Engine 8oz
  • Automatic transmission 3oz
  • Manual transmission 8oz
  • Differential oz

Important Application Instructions

For treating a diesel engine and or automatic transmissions which must be at operating temperature then turn off the engine, and apply MoreMPG to the engines oil and or Automatic transmission. After application immediately turn the engine back on, at this point the engine should be reved up to around 1200 rpm for 2 minutes to allow the product to spread out through the engine. Then immediately drive for a minimum of 50km for Diesel Engines. Differentials and manual transmissions can be applied while the unit is cool.

Commercial and Industrial Diesel Engines Over 300HP to 700HP

johnwayne Disel engines such as Semi-trucks between 300 HP to 650 HP require 16oz bottle for the engine treatment. For optimum performance we strongly recommend applying MoreMPG to the Transmission and differential.

  • Engine 16oz
  • Automatic transmission 3oz
  • Manual transmission 8oz
  • Differential 8oz each

semi dosage

Important Application Instructions

For treating a diesel engine and or automatic transmissions which must be at operating temperature then turn off the engine, and apply MoreMPG to the engines oil and or Automatic transmission. After application immediately turn the engine back on, at this point the engine should be reved up to around 1200 rpm for 2 minutes to allow the product to spread out through the engine. Then immediately drive for a minimum of 50km for Diesel Engines. Differentials and manual transmissions can be applied while the unit is cool.

Working Hours:

Monday: 09.00am to 17.00pm

Tuesday: 09.00am to 17.00pm

Wednesday: 09.00am to 17.00pm

Thursday: 09.00am to 17.00pm

Friday: 09.00am to 17.00pm

Saturday: On Call

Sunday: Closed